Regular inspection and maintenance of the water heater and vent-air intake system will help to insure safe and reliable operation. 1. Magnesium Anode-Hot Water Outlet 20. Heater Leg 7. Dip Tube-Cold Water Inlet 21. Thermocouple Lead 8.
What type of maintenance should I do on my water heater? D&V Commercial service techs are always available to perform any maintenance or repairs to your water heater – from periodic checks on the anode rod to ensuring that all
maintenance section of this manual for more information regarding vent system inspections.! DANGER! anode(s) supplied in this water heater is slowly consumed , thereby eliminating or minimizing corrosion and protecting the glass lined tank.
The water heater user soon becomes dissatisfied with Anode deterioration depends on water conductivity, not necessarily water condition. A corroded or pitted anode rod clean; maintenance should be as indicated until experience
INSTALLATION AND MAINTENANCE INSTRUCTIONS MOUNTING THE HEATER Replaceable anode inside this removable nipple \ 12.gal. the water heater. turn on water pressure pump. AIIow pump to run a few minutes to expel air from the
Shutdown problems and prolong the maintenance of the water heater’s inlet ﬁ lter. A water softener can affect the Each water heater contains at least one anode rod, which will slowly deplete (due to electrolysis) prolonging the life
maintenance of the electric water heater. It also contains warnings corrosion protective action of the anode. Smelly water may be eliminated or reduced in some water heater models by replacing the anode(s) with one of less active material, and
heater by corroding themselves so the water heater doesn't. These anode rods are easy to install! NOTE: DO NOT OPERATE HEATER WITHOUT ELEMENT BEING SUBMERGED IN WATER. MAINTENANCE 1. Check heat exchanger lines for leaks at regular intervals.
RESIDENTIAL ELECTRIC WATER HEATER This information is intended to supplement service and maintenance information found in the heater installation and operation manual. 1 Turn off the heater. 2 Remove the anode. 3 Flush the tank thoroughly with water.
PREVENTIVE MAINTENANCE – OPERATION & SERVICE – TROUBLESHOOTING. 2 anode rod, and the water heater tank. The electronic control monitors conditions in the tank and produces a voltage that will prevent galvanic corrosion from occuring.
The rod is referred to as a sacrificial anode. 4 Background – water heater issues to be aware of A recent consumer-based study examined the interiors of 18 different heaters and, water leak. Maintenance defects When considering the degraded condition
B. Anode Protection – Water Heater Each Suburban water heater is equipped with a replaceable anode rod. The sacrificial anode maintenance for a period of one year from date of purchase whether or not actual use begins on that date.
Installation, operation and maintenance of your oil fired water heater and provide important safety information in these areas. corrosion and prolonging the life of the water heater. Once the anode is depleted, the tank will start to corrode, eventu-ally developing a leak.
Magnesium anode — The water heater is equipped with a magnesium sacrificial anode. The anode may erode over time, and should be inspected at least once annually, only Water heater maintenance Boiler water — read and comply with all requirements under
Each water heater contains at least one anode rod for corrosion protection of the tank. Certain water conditions will cause a reaction between this rod and the water. venting before resuming operation of the water heater. BLOWER MAINTENANCE
If you are not sure if the anode rod on your water heater is accessible, please call technical support at 800-432-8373. These instructions will walk you thru the replacement of an anode rod in a residential gas or electric water heater.
OPERATION, AND MAINTENANCE OF YOUR INDIRECT WATER HEATER AND TO PROVIDE IMPORTANT SAFETY INFORMATION. INSTALLER RESPONSIBILITIES heater is installed. If the anode rod had reduced in size by two-thirds of its original diameter of
Routine Maintenance on the Water Heater Draining the Water Heater / Winterizing . the water to cool. 1. Turn off the water heater (110V and LP) Before draining the tank or changing the anode rod, turn the water heater off and allow the water to cool.
Installation, operation and maintenance of your gas water heater and provide important safety information in these areas. corrosion and prolonging the life of the water heater. Once the anode is depleted, the tank will start to corrode, eventu-ally developing a leak.