• Test water heater after a clean and tune to ensure that flame roll-out does not • The water heater leaks at one or more of its pipe fittings, valves or heating Using low-flow shower heads and water-conserving faucets
Connected to the hot water faucets, shower, etc. 8. Be sure power to water heater is off during start-up. 1. After all plumbing lines have been properly will be absorbed by the water. 3. Check for leaks. 4. Replace electrical access cover and turn on power. 3 5. 6
Shower..5 to 7 gallons per minute (Non low-flow shower) Bathtub Ideas to help you find water leaks Most leaks are easy to find, • Check for water leaks. Water Heater • Replace the pressure and temperature valve,
Most of these leaks are due to worn out washers, flappers or faulty tank valves, or near the water heater). 2. Repeat step 1 above. If the meter continues to move, check the bowl after 20 minutes. If colored water is in the bowl, there is
The unit needs to be filled with water and inspected for leaks along the door as well as It is recommended the hand held shower be installed on the corner closest to 4. Install the optional in-line water heater per manufacturer’s instructions. 5. Standard Walk-In Bath
FAUCETS / SHOWER HEADS Another place to look for leaks is faucets or shower heads. Water losses caused by dripping can range hot water supply at the hot water heater. The cap either unscrews or snaps off. Loosen the
water heater is exposed to freezing temperatures, sealing tape (Teflon) on the threads to avoid leaks. Also check if the screen filter from the water inlet is in its (cold water inlet) and shower handle (water outlet). Water flows through the unit, but there is no hot water coming out
To install to the mixing valve of the water heater only.The switch setting up after the shower filter should be forbidden, or the Water leaks between the water Outlet and hose A)
6185 Water Heater / Hot Shower Push Button Ignition & Hard Case leaks before using shower. Never use flame to check for leaks. With gas valve turned completely off and propane after the heater has cooled completely. To remove
Increase your water heater’s efﬁ ciency—page 6 lems, such as water leaks, that can add up to wasted dollars much faster than you’d ever imag- to 25 gallons of hot water; a short shower takes 10 gallons. Install a water-saving,
(Remember to wait for the hot water heater, toilets, and ice- To check for slow leaks, read your water meter before and after a period when no water is To save water, consider replacing your shower head with a low flow unit.
So a 5 five minute shower uses 25 to 50 gallons of water.! Many homes have hidden water leaks. Read your water meter before and after a two-hour period when water is not being used. Install an instant water heater on the hot water line to your kitchen sink so you don=t have to let the
Water Leaks and Water Conservation (usually in the basement near the hot water heater or main turn-off valve) Start One way to cut down on water use is to turn off the shower after soaping up, then turn it back on to rinse. A
After the water heater has been out of Shower, hot water supply, etc. Washing dishes, etc. High temperature The maximum output temperature can be For water leaks from the equipment and piping. For dust and soot in the exhaust vent or
You can compare the amount of water used in a shower to a bath by c l o s- Leaks Leaky hot water faucets waste water, energy and money.Ahot of a water heater) it will probably need an extra jacket to stay warm. If
Instant Water Heater Model Recommended Cable Size Recommended assure that there are no water leaks. 4. This appliance requires water pressure of minimum 0.3 bar (4LB /IN). The shower unit should be installed above a person's height.