Stop! do not plug this unit in until you read and follow the directions on the reverse side of this page! more tips from american pacific to conserve energy
For do-self repairs INSTALLING A GAS WATER HEATER While it appears to be a complex job, installing a water heater is really quite straightforward.
Building construction permits over $10,000 in value that were approved in Boulder between July 29 and Aug. 4, 2013. Listed below are: the case number; address; total project valuation; owner name; contractor (if applicable); and description.
Installation and operation manual direct vent gas water heater models sw6d • sw6de • sw6dm • sw6dem for installation in recreational vehicles and mobile housing
Do not install the water heater in outdoor, unprotected areas or near any other appliances where high temperatures are present, such as wood burning stoves, boilers, or furnaces. High temperatures can warp or otherwise damage the non-
install a water heater suitable for the altitude at the location it is intended to serve, can result in improper operation of the appliance resulting in property damage and/or, producing carbon monoxide gas which could result in personal injury, or death.!
Do not install water heater where flammable products will be stored or used unless the main burner flame is at least 18" above the floor. This will reduce, but not eliminate, the risk of vapors being ignited by the main burner flame.
238-16152-00K REV 05/07 COMMERCIAL ELECTRIC WATER HEATER La version espanola de estas instrucciones se puede obtener al escribirle a la fábrica cuyo nombre aparece in la placa de especificaciones.
Install the tankless water heater in a frost free area. If frost may occur, remove the unit before freezing temperatures set in. 3. Leave a minimum of 12" of clearance on top and bottom of the unit for servicing. Mounting The Water Heater
Do not install the water heater near vents for heating or cooling . A minimum of 4 feet (1 .2 m) should be maintained . Minimum water heater clearance from combustible and non-combustible construction is 1/2” (1 3 cm) sides, 0” rear
install a water heater suitable for the altitude at the location it is intended to serve, can result in improper operation of the appliance resulting in property damage and/or producing carbon monoxide gas, which could result in personal
MartWaterHeat org Generate customer referrals and increase sales through quality installations Tier 1 Tier 2* Unconditioned space installation Conditioned space installation
RON NYBO, CBO Building Official City of Boulder City Community Development Department Building & Safety Division 401 California Avenue, Boulder City, NV 89005-2600
Install the new Hot Water Outlet Nipple/Anode. Reconnect the hot-water piping to the Hot Water Outlet Restart the water heater following the “Lighting Instructions” found in the Operating Manual. 1. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23.
Before spending money on repairs, check anode rod. Open drain valve and drain water heater. If there is rusty water, then check anode If anode rod is depleted, then install new anode to prevent steel tank from rusting.
WARNING: Raritan Engineering Company, Inc. recommends that a qualified person or electrician install this product. Equipment damage, injury to personnel or death could result from improper
Installing the water heater. The location chosen for the water heater must take into consideration the following: Local Installation Regulations
If the water heater is taller than 48", repeat the above wrapping process on the exposed heater section and tape the seams. 3. For electric water heaters only: Cut out a circular piece of insulation to cover the top of the heater.
Opening provided and marked for this purpose on the water heater. Install a discharge line so that water discharged from the combination temperature and pressure relief valve will exit within 6 in. (15.3 cm) above, or any distance below the structural floor and